- All chemicals should ideally be Ph neutral or balanced.
- The coating should be regularly maintained and looked after using washing and maintenance methods provided by your installer.
- Your installer should have a maintenance program or plan in place. Attend a maintenance lesson or set up a phone call to get maximum performance out of your investment.
- Never rinse without drying.
- Should you see mineral spots on your coating, contact your installer IMMEDIATELY to get best advice on how to remove it.
- After delivery from the installer the aftercare is in your hands and neither Titan Technologies or installer will be held accountable for the following - Damage by collision, accident, scratches, abrasion, vandalism, stone chipping, burn, rust, water spots, clear coat damage other paint/coatings or chemicals not designed for use on automotive paint.
- If properly cared for the paintwork of your vehicle will be in showroom condition for years to come.
- Regular wash every 2-4 weeks
- Paintwork should be as clean as possible before contact wash.
- Never wash in direct sunlight and let every panel cool down for 30 minutes if needed.
- Avoid chemicals drying on the paintwork. Apply more if needed.
- Pre-wash your car with either a pre-wash solution or pressure washer.
- Apply TAR remover and let sit until tar is dissolved. Rinse off.
- Contact wash with Ph neutral SHAMPOO using a microfiber wash mitt. Rinse off.
- Dry the car thoroughly using a microfiber towel. Titan coatings Ultra 4.0 can be used as a drying aid. Spray one to two sprays per panel when wet then dry using a microfiber towel.
- When washing your car you want to use chemicals to clean it mostly without touching to avoid scratching or marring. When contact washing, dip your wash mitt into the SHAMPOO solution and wash one panel at a time then get more SHAMPOO. This will ensure you have enough washing solution and lubrication.
- Decon wash every 4-6 months
- Paintwork should be as clean as possible before contact wash.
- Never wash in direct sunlight and let every panel cool down for 30 minutes if needed.
- Avoid chemicals drying on the paintwork. Apply more if needed.
- Pre-wash your car with either a pre-wash solution or pressure washer.
- Apply TAR remover and let sit until tar is dissolved. Rinse off.
- Apply IRON remover and let it sit for 5-10 minutes. Do not rinse off.
- Contact wash with Ph neutral SHAMPOO directly over the IRON remover using a microfiber wash mitt. Rinse off.
- Apply a “coating safe” MINERAL remover on one panel at a time. Agitate with a long pile microfiber cloth or wash mitt with little or no pressure. Rinse off.
- Avoid spraying MINERAL remover on glass.
- Contact wash with Ph neutral SHAMPOO using a microfiber wash mitt to neutralize any unwanted chemicals.
- Dry the car thoroughly using a microfiber drying towel.
- Apply 2 layers of Titan coatings Ultra 4.0
- When washing your car you want to use chemicals to clean it mostly without touching to avoid scratching or marring. When contact washing, dip your wash mitt into the SHAMPOO solution and wash one panel at a time then get more SHAMPOO. This will ensure you have enough washing solution and lubrication.